ERROR data in table above were used.

ERROR IN THE POSITION OF FLUX LINKAGE WITH DTC ERROR IN THE POSITION OF FLUX LINKAGE WITH FUZZY TIME0 0 03.3 0.9 12.2 0.06 22.5 0.07 32.

45 0.0643 4Figure 4.2 Simulated result for flux linkage error using DTC and fuzzy logic with duty ratio.In the analysis, the data in table above were used. The flux behaviour of the motor using only DTC and fuzzy logic with duty ratio control for a step torque command of 2.

Don't waste your time
on finding examples

We can write the essay sample you need

4Wb with the drive output updated at a rate of 5kHz were used, the flux ripple generated was 4.67Wb (18-13.33)Wb greater and lesser values with the ordinary DTC while fuzzy logic with duty ratio Figure 4.

2 Simulated result for flux linkage error using DTC and fuzzy logic with duty ratio.In the analysis, the data in table above were used. The flux behaviour of the motor using only DTC and fuzzy logic with duty ratio control for a step torque command of 2.4Wb with the drive output updated at a rate of 5kHz were used, the flux ripple generated was 4.67Wb (18-13.33)Wb greater and lesser values with the only DTC while fuzzy logic with duty ratio control the ripple is reduced to 0.667Wb (2.4-1.733)Wb higher and lower values respectively, neglecting the under shoot in the flux value at the beginning of each voltage sector.

x

Hi!
I'm Owen!

Would you like to get a custom essay? How about receiving a customized one?

Check it out